1-8Channels BNC TO UTP Passive Video Transceiver
The passive (no-amplified)device
that allows the transmission of real-time monochrome or color video
over Unshielded Twisted-Pair(UTP)telephone wire. Baseband (Composite)signals
of any type aresupported.
Up-the-coax type P/T/Z
signals can be sent over the same wire. Used as a receiver, the
4channel Video Transceiver is fully compatible with other balance
The unparalleled interference rejection and low emissions of the
1~8channel Video Transceivers allow video signals to co-exist in the
same wire bundle as telephone, datacom, or low-voltage power
circuits. This allows the use of shared or existing cable plant.
With built-in transient protection, damaging voltage spike problems
Four passive transceiver channels in one product.
Full-motion CCTV video at distances up to 750ft (225m)when used with
Up to 300ft(1km) with an active receiver.
No power required.
Exception interference rejection.
Built-in polarity protection.
Frequency Response DC to 5 Mhz
Attenuation 0.5dB type
Common-mode / Differential-mode Rejection
15KHz to 5 Mhz 60 dB type
Coax, female BNC 75 ohms
UTP, Terminal Block 100 ohms
Network Wiring One Unshielded Twisted Pair 24-16 AWG
Category Type Cat 5 or better
Impedance 100 ¡À 20 ohms
DC Loop Resistance 52 ohms per 1,000 ft (18 ohms per 100 m)
Differential Capacitance 19 pF/ft max (62 pF/m max)
No external power required
Temperature -20¡ãCto +75¡ãC
Humidity (non-condensing) 0 to 95%
Transient Immunity per ANSI/IEEE 587 C62.41
Dimensions excluding BNC 184mm¡Á60mm
Mounting Two 4.4mm diameter holes, 171.5mm apart